Most leaks don't need a new roof — they need the actual source found and properly sealed. We trace leaks to their real origin (often flashing, a penetration, or a failed membrane seam, not where the stain shows up inside), then apply commercial-grade waterproofing systems built for Florida's rain and heat.
On-site leak diagnostics to trace water back to its actual entry point
Self-adhering rubberized membrane for full-section waterproofing
Liquid-applied elastomeric sealants for flat and low-slope areas
Flashing resealing around chimneys, skylights, and roof penetrations
Ponding-water correction on low-slope and flat sections
Post-repair inspection to confirm the leak is actually resolved, not masked
Water travels before it shows up as a stain, so we inspect the roof surface, flashing, and penetrations methodically rather than guessing from the interior damage location alone.
A membrane is a physical waterproof sheet adhered to the deck, typically used under tile or during a re-roof. A coating is a liquid-applied, flexible layer painted onto an existing surface — common for flat and low-slope roofs that don't need a full tear-off.
Often, yes. If the structure and existing covering are sound, targeted waterproofing can extend the roof's life significantly without the cost of full replacement.
It depends on the roof type and sun exposure, but flat and low-slope coated roofs typically benefit from inspection every 2–3 years given Miami-Dade's UV exposure and rain volume.
Licensed and insured, based in Hialeah, FL since 2016. Call, email, or request a consultation online.